Install Wall Switch Kit (Recommended) - Valor 1500IN (NG) Installation & Owner's Manual

Install Wall Switch Kit (recommended)

CAUTION
DO NOT PUT BATTERIES IN THE REMOTE
CONTROL RECEIVER OR THE BATTERY BOX
until the wires are connected to the burner
control unit as short-circuit could result in the
destruction of the electrical components.
The wall switch kit is provided with this appliance. It is
connected to the receiver in the fi replace. The receiver
is located on the left side of the appliance, left of the
control valve behind the appliance's front panel. The
battery box is located on the right hand side of the
appliance under the fi rebox.
1. Decide where the switch is to be installed on the
wall. Install an electrical outlet box or mud ring as
required (not supplied) to house the switch controls.
2. Thread the switch wire through an access hole in
the appliance.
CAUTION
Do not run the switch wire over the top of the
fi rebox. Route the wire so it does not contact the
fi rebox.
3. Pull out the receiver and the battery boxes. Remove
the batteries from the receiver or battery box if
they contain any. You can remove the ignition wire
to improve access to the receiver.
CAUTION
DO NOT USE a screwdriver or other metallic
object to remove the batteries from the battery box!
This could cause a short circuit to the receiver.
4. Take the switch wire and plug it into the receiver's
connection slot as indicated (the other slot should
already be fi tted with the valve's wire harness
connector). See diagrams below.
IMPORTANT: The connection can only be done
one way. Do not force it or damage the pins!
5. On the outside of the fi replace, run the switch wire
into the outlet box. Use insulated type staples to
secure the wiring to framing.
6. Plug the wire into the switch plate and to the outlet box.
7. Reconnect the ignition wire to the receiver if it was
previously removed.
IMPORTANT: Make sure the ignition wire DOES
NOT TOUCH the receiver's antenna.
Installation
Receiver
The receiver and battery box are located inside
the front panel of the appliance.
Wall Switch Harness
Valve Wire Harness
Ignition Wire Connection
(spade type connector)
Be careful when removing
and reinstalling: not to
bend or break the spade
connector
QUALIFIED
INSTALLER
Battery box
IMPORTANT: The connection
can only be done one way.
Do not force it or damage the
pins on the receiver box!
Ignition Wire
Antenna
49