Valor 1500IN (NG) Installation & Owner's Manual page 14

OWNER'S
INFORMATION
Timer Programming Example (default temperatures shown)
6:00 a.m.—
☼
P1
Start time
☼
Set temp 74˚F
AUTOMATIC TURN DOWN
• No communication. If there is no communication
between the receiver and the handset for a period of
6 hours, the appliance goes into pilot mode.
• No change in fl ame height. If there is no change
in fl ame height for a period of 6 hours, the appliance
goes into pilot mode.
NOTE: In TEMP or TIMER modes, the fl ame height
will vary according to room temperature. The appli-
ance will continue to work normally. However, if the
room temperature remains the same for 6 hours, the
appliance will go into pilot mode.
AUTOMATIC SHUT OFF
• Low batteries in the receiver. With low battery
power in the receiver the system shuts off
completely.
NOTE: This does not apply when the power supply
is interrupted.
• No change in pilot. The appliance shuts off
completely when it is continually in pilot position—
without any change—for a period of 5 days.
14
Remote Control Operation
8:00 a.m.—
☽
P1
End time
☽
Set temp 40˚F
4:00 p.m.—
☼
P2
Start time
☼
Set temp 74˚F
LOW BATTERY INDICATION
DO NOT USE a screwdriver or other metallic
object to remove the batteries from the battery box
or the handset! This could cause a short circuit.
Remote handset: The battery icon
when the battery needs to be replaced.
Replace with one 9 V alkaline battery.
Battery box: Three short 'beeps' will sound when the
motor turns when the batteries need to be replaced.
Replace with four 1.5 V alkaline batteries.
HANDSET / RECEIVER MATCH
The remote control handset and receiver are program-
med to function together. In case of a replacement of
the handset or the receiver, you will need to reset the
receiver to allow them to function together. Contact your
dealer for details.
10:00 p.m.—
6:00 a.m.—
☽
P2
P1
End time
Start time
☽
Set temp 40˚F
CAUTION
will show
☼