Valor 1500IN (NG) Installation & Owner's Manual page 13

SETTING PROGRAM TIMERS
• You can program two periods of time between 12:00
am and 11:50 pm in each 24-hour cycle.
• The Programs P1 and P2 must be set in the
following order during a 24-hour cycle:
and .
P2 P2
• The icon indicates the beginning of the period (ON)
and the icon indicates the end of the period (OFF).
• If = or
P1 P1 P2
is cancelled.
• To keep the fi replace ON all night, set
11:50 am and
P1
Default settings:
Program 1: 6:00 am
P1
Program 2: 11:50 pm
P2
• Briefl y press SET button to scroll to
TIMER mode.
SETTING P1 ON TIME
• Hold the SET button until
(sun) is displayed and the time
fl ashes.
• Press
set the hour.
• Press
set the minutes.
Remote Control Operation
,
P1 P1
= , the programming
P2
at
P2
at 12:00 am.
8:00 am
P1
11:50 pm
P2
P1
(large fl ame) button to
(small fl ame) button to
SETTING P1 OFF TIME
• Briefl y press SET button to scroll
,
• Press
• Press
SETTING P2 ON TIME
• Briefl y press SET to scroll to TIMER mode
(sun) while the time fl ashes.
• Follow the instructions given to set P1 ON time.
SETTING P2 OFF TIME
• Briefl y press SET to scroll to TIMER mode
(moon) while the time fl ashes.
• Follow the instructions given to set P1 OFF time.
Press OFF button to save these settings. The timers
are programmed. See the diagram on programming
sequences on the following page.
Tip
If you want to program only one period, program
and with desired times and program
P1
with the same time as
P2
OWNER'S
INFORMATION
to TIMER (moon) while the
P1
time fl ashes.
(large fl ame) button to set
the hour.
(small fl ame) button to
set the minutes.
P2
.
P1
P2
P2
P1
and
13