Checking Pilot And Burner Flames - Valor 1500IN (NG) Installation & Owner's Manual

ing agents nor polishes should be used. Dry stains can
be removed using a white or light colored cloth with mild
soap and warm water when the material is cool, then
dried immediately. If the stain is hard to remove, use a
white or light colored synthetic scrub pad (not steel wool)
and dry immediately. In case of an accidental spill, soak
up the liquid IMMEDIATELY with a dry cloth and follow
up with a wipe down with a wet cloth.
Clean the barrier screen dusting it with a soft brush.
Clean the fi rebox ceramic logs/rocks and walls dust-
ing them with a soft brush. Dust can also be removed
from the burner using a soft brush after removing the
ceramic logs. When cleaning, make sure that no par-
ticles are brushed into the slots of the burner.
WARNING
!
CHOKING HAZARD! Ensure that the fi replace
area is clear of fi re glass or vermiculite particles as
these could be ingested by small children. Vacuum
thoroughly around the fi replace area after cleaning.
To refi t the window:
1. Place it in its bottom railing and push its top against
the fi rebox.
2. While you hold it, pull the side levers back into the
window brackets on each side.
IMPORTANT: To ensure a safe operation, verify
that the levers are hooked properly to the window
tabs; then, pull out the top of the window and
release it to insure the springs return it.
3. Apply light hand pressure against the window frame
sides to bed-in the window seal.
4. If the Hot Glass Warning plate has been removed
from the front lower corner of the window,
reinstall it by sliding it between the glass and
the frame as indicated.
Hot Glass Warning Plate
5. Reinstall the barrier screen on the trim.
WARNING
!
FOR SAFETY PURPOSE, ensure the barrier
screen is re-installed on the fireplace front
after maintenance.
Owner's Information
a) 1555 1" trim: Insert the screen's top tabs in the
slots in the convection baffl e then rest the screen
bottom tabs on the edge of the opening in the
plinth to lock it in position.
b) 1550 3.5" and 1570 trims: Hook the bottom
of the screen to the bottom edge of the trim's
front plate, then, with the top levers up, push the
screen against the fi replace. Rotate the levers
down to hook them up to the trim and slide them
inwards to secure them.
6. Verify that the screen is properly hooked to the trim
and secure.

Checking Pilot and Burner Flames

A periodic check of the pilot and burner fl ames should
be made. Check after the fi re has been on for at least
30 minutes. The pilot fl ame must cover the tip of the
thermocouple probe. The main burner fl ame pattern will
vary from appliance to appliance depending on the type
of installation and climatic conditions.
Pilot Flame can be seen
between the front and
rear left logs
Long Beach Driftwood Kit Correct Flame Picture
Pilot Flame can
be seen left of
the fi re bed
Murano Glass Fire Correct Flame Picture
Pilot Flame can
be seen left of
the fi re bed
Murano Bead Fire Correct Flame Picture
Pilot Flame
OWNER'S
INFORMATION
Thermocouple Probe
must be in Flame
7