Connect A Bluetooth Scanner Rs507 Directly To The Vc70 (Spp Profile) - Motorola VC70N0 Product Reference Manual

Connect a Bluetooth Scanner RS507 Directly to the VC70 (SPP Profile)

NOTE Refer to the scanner Product Reference Guide for information on configuring the scanner.
NOTE To improve performance, use StoneStreet One Bluetooth stack.
To connect a Bluetooth scanner to the VC70:
Ensure that the scanner battery is fully changed.
1.
Scan a SPP Profile bar code to configure the scanner to Bluetooth SPP profile mode before the pairing.
2.
SPP Profile Bar Code
Figure 5-54
Perform a cold boot by removing and re-installing the battery onto the RS507.
3.
Enter the following configuration details:
4.
•
Tap
> Programs > BTScannerCtlPanel
•
Check
BT Scanner
•
Select Comm port
COM9
•
Tap and
Save Exit
To pair the scanner with your VC70, scan the
5.
beeps indicating that it is successfully connected to the VC70 and Authentication Request box is displayed.
Authentication Request Box
Figure 5-55
Tap to allow pairing.
6. Yes
From Wavelink web site, download l the Wavelink MOT_VC7000_CE7 TelnetCE application
7.
(https://www.wavelink.com/Orders/files/WLTE_MOT_VC7000_CE7_7_3_158_AS.exe)
Install the Wavelink MOT_VC7000_CE7 TelnetCE application on a PC used for configuring the VC70.
8.
bar code on the upper right side of the VC70. The scanner
PAIR
TelnetCE Configuration 5 - 45