Motorola VC70N0 Product Reference Manual page 102

4 - 16 VC70 Vehicle Computer Product Reference Guide
USB Connector
Connecting DS3578/LS3578 USB Scanner Cradle to VC70
Figure 4-33
Connect DS3578/LS3578 Scanner Cradle to a Serial Port of the VC70
The DS3578/LS3578 scanner cradle is used only for charging the DS3578/LS3578 Scanner.
To connect the cradle:
Connect the serial scanner cable to the cradle (use cable P/N CBA-R49-C09ZAR).
1.
Connect the serial scanner cable to the COM1 port of the VC70.
2.
COM1 Port
Connecting Serial Scanner Cradle to COM1 Connector
Figure 4-34
NOTE The connected scanner is powered from the COM1 port of the VC70.
By default, after the VC70 boots, the COM1 port remains powered off.
In the current revision (C), scanner power is enabled whenever the scan application starts (the scan
application calls Com open as in the standard CE Com port API). Power to the scanner is disabled when
the scan application is closed (when the scan application calls Com close).
The current revision (C) differs from the legacy revision (B) where the user manually enabled the scanner
power via applet or registry settings.
To enable scanner power in revision C via the applet or registry (as in revision B), refer to
Output to Scanner on page
power remains on (the Com port API is overwritten on the scanner power control and the scanner power
will not turn off when the scan application calls Com close).
11-4. When the scanner is enabled via the applet or registry, the scanner
Cable PN: CBA-R49-C09ZAR
COM1 Power