Motorola VC70N0 Product Reference Manual page 185

Tap .
30. Save
NOTE If re-editing is required, tap Options > Configure > Host Profiles and enter default password: "system".
tap OK to continue.
Tap
31. Options > Connect Session 1
connected to the host system. The bar code data will show on the black screen. The bar code data will show
on the black screen.
When completing scanning, scan the unpair label bar code in the upper left side of the VC70. This will
32.
disconnect your scanner from the VC70.
To unpair the scanner from the cradle, scan the Unpairing bar code.
33.
Unpairing Bar Code
Figure 5-98
Connect DS3578/LS3578 Scanner Cradle to USB Port of the VC70
The DS3578/LS3578 scanner cradle is used only for charging the DS3578/LS3578 Scanner.
To connect the cradle:
Connect the USB scanner cable (PN 25-159548-01) to the cradle.
1.
Connect the USB scanner cable to the one of the VC70 USB ports.
2.
USB Connector
Connecting DS3578/LS3578 USB Scanner Cradle to VC70
Figure 5-99
Connect DS3578/LS3578 Scanner Cradle to a Serial Port of the VC70
The DS3578/LS3578 scanner cradle is used only for charging the DS3578/LS3578 Scanner.
To connect the cradle:
Connect the serial scanner cable to the cradle (use cable P/N CBA-R49-C09ZAR).
1.
Connect the serial scanner cable to the COM1 port of the VC70.
2.
On the Edit Host Profile box, verify the Alias name and tap
and scan a bar code to scan a bar code to verify that the scanner is properly
TelnetCE Configuration 5 - 69
.
Done