Connect A Bluetooth Scanner Rs507 Directly To The Vc70 (Spp Profile) - Motorola VC70N0 Product Reference Manual

Connect a Bluetooth Scanner RS507 Directly to the VC70 (SPP Profile)

NOTE Refer to the scanner Product Reference Guide for information on configuring the scanner.
To connect a Bluetooth scanner to the VC70:
Ensure that the scanner battery is fully changed.
1.
Scan a SPP Profile bar code to configure the scanner to Bluetooth SPP profile mode before the pairing.
2.
SPP Profile Bar Code
Figure 4-58
Perform a cold boot by removing and re-installing the battery onto the RS507.
3.
From the VC70 Desktop, tap
4.
Tap:
5. Advanced Configuration > Profiles > Profile0 > Input > Serial COM9: > Enabled.
Tap to return to
6. Back Profile0
Tap
7. Input > Route > Route0 > Input > Plugin > Serial
To pair the scanner with your VC70, scan the pair label bar code in the upper right side of the VC70.The
8.
scanner beeps indicating that it is successfully connected to the VC70.
Tap to go back to DataWedge main screen.
9. Back and Exit
On the DataWedge main screen, select
and verify that the scanner is in
Ready to Capture Window
Figure 4-59
to launch the DataWedge application.
.
.
and start the DataWedge process by changing the status to
Running
.
Status: Ready
DataWedge Scanner Connection 4 - 29
Yes