Motorola VC70N0 Product Reference Manual page 141

From the Emulation Parameters screen Scanner > Common folder, click No Scanner Configuration and
17.
change to
Do Not Configure Scanner
Emulation Parameters - No Scanner Configuration Screen
Figure 5-42
From the Emulation Parameters screen select File > Save.
18.
From the Emulation Parameters screen select File > Exit.
19.
Verify that the VC70 is properly connected to the PC (see
20.
From the Wavelink Product Configuration screen, click on the
21.
From the VC70 Desktop, Tap
22.
TelnetCE Client launches on the VC70 and displays the Scanner Selection notification. Tap
23.
with "
No host connection
On the black screen, tap
24.
TelnetCE Client shows the following notification: "
25.
". Tap
Host Profile? Yes
Enter the following Host Profile information:
26.
•
Indicates the name of the host profile. Usually, this is the name or alias of the host system with which
Alias:
the VC70 creates a Telnet session.
•
Indicates the type of emulation that the host system uses. Available Options: <IBM-5251-11>
Emulation:
<IBM-3278-2> <IBM-3279-2> <IBM-3279-2E> <VT100> <VT220> <HP>. Default: <IBM-5251-11>
•
Indicates the IP address or host name of the host system. Possible Values: Valid IP address of the
Address:
running terminal emulation or host name.
•
Indicates the TCP port on which the host system is listening for Telnet connections. Possible Values: 0 -
Port:
65535. Default: 23 for Telnet server.
•
Secure Shell (SSH) is a cryptographic network protocol for secure data communication. Check the
box if required.
encryption
.
> Programs > TelnetCE
" indication shows.
Options > Connect Session 1
No Host Profiles have been configured. Would you like to add a
to continue.
TelnetCE Configuration 5 - 25
Chapter 8, Sync with Host
button.
Config Only
to start TelnetCE.
.
Computer).
; a black screen
No
Use SSH