Connect a Bluetooth Scanner DS3578 Directly to the VC70 (SPP Profile)
NOTE To improve performance, use StoneStreet one Bluetooth stack.
To connect a Bluetooth scanner to the VC70:
Ensure that the scanner battery is fully changed.
1.
Reset the scanner by removing and re-installing the scanner battery.
2.
Scan the
3.
Set All Defaults
Set All Defaults Bar Code
Figure 4-35
NOTE The Set All Defaults Bar Code allows the scanner to reset from any previous configuration to the default
configuration.
Scan a
bar code to configure the scanner to Bluetooth SPP profile mode before the pairing.
4.
SPP Profile
SPP Profile Bar Code
Figure 4-36
Scan Write to Custom Defaults bar code.
5.
Custom Default Bar Code
Figure 4-37
To pair the scanner with your VC70, scan the pair label bar code on the upper right side of the VC70.The
6.
scanner beeps indicating that it is successfully connected to the VC70.
Enter the following configuration details:
7.
•
Tap
> Programs > BTScannerCtlPanel
•
Check
BT Scanner
•
Select Comm port
COM9
•
Tap
and
Save
Exit
From the VC70 desktop, tap
8.
On the DataWedge main screen, tap
9.
Tap
10.
Advanced Configuration > Profiles > Profile0 > Routes > Route0 > Input > Plugin > Serial.
Tap
until you return to
11.
Back
bar code.
to launch the DataWedge application.
to show
Running
screen
Profile0
.
DataWedge Scanner Connection 4 - 17
.
No