Electrical - Nikon ECLIPSE L200ND / ECLIPSE L200N Instructions Manual

5.2

Electrical

Trouble
Lamp does not light when
switched on.
Lamp flickers.
Unstable brightness.
5 Troubleshooting
Table-8 Troubleshooting (electrical)
Causes
No electricity.
(Power cord not connected.)
No lamp installed.
Lamp is blown.
Episcopic/Diascopic illumination
selection switch not set correctly.
Specified lamp not used.
Lamp about to blow.
Power cord or lamphouse not
connected securely.
Lamp not securely inserted in the
socket.
52
IC Inspection Microscope ECLIPSE L200ND / L200N Instructions
Countermeasures
Connect the power cord
(See "4.12 Connecting the
power cord".)
Install the lamp.
(See "4.4 Attaching the
lamphouse and replacing the
lamp".)
Replace the lamp.
(See "4.4 Attaching the
lamphouse and replacing the
lamp".)
Switch it correctly.
Use the specified lamp.
(See "7 Technical
Specifications".)
Replace the lamp.
(See "4.4 Attaching the
lamphouse and replacing the
lamp".)
Connect them securely.
(See "4.4 Attaching the
lamphouse and replacing the
lamp" and "4.12 Connecting
the power cord".)
Insert securely into the socket.
(See "4.4 Attaching the
lamphouse and replacing the
lamp".)