Nikon ECLIPSE L200ND / ECLIPSE L200N Instructions Manual page 43

Figure-36 Attaching the diascopic lamphouse (for simultaneous illumination)
Front
POWER switch
Flip the power switch to the " I " side to turn
on the power supply. DC power is output
from the 12VDC outlet on the back. Flip the
power switch to the " " side to turn off the
power.
POWER indicator
Brightness control knob
This knob adjusts the lamp brightness.
(For details, see the instruction manual supplied with the power supply.)
3 Operation of Each Part
Diascopic
lamphouse
Lamp cable
TI-PS 100W
Power Supply
Figure-37 TI-PS 100W Power Supply
29
IC Inspection Microscope ECLIPSE L200ND / L200N Instructions
Rear
The equipment is designed for AC power of 100
to 240V AC and 50/60 Hz. Before connecting
the power cord, check that the power supply to
be used conforms to the voltage and frequency
described above.
EXTERNAL connector
Connect a desired external control
device to this connector. Cannot be
used for the connection with the
L200ND microscope.
Connect the lamp cable from the
compatible lamphouse to this connector.
EXTERNAL ON/OFF switch
Set this switch to OFF.
The AC power supply is connected here. Be sure
to use the specified power cord when connecting.
Power cord
Rating label
12VDC outlet
AC inlet