Electrical - Nikon ECLIPSE E200 MV Series Instruction Manual

Electrical

3
Causes
No electrical power.
Power cord is not connected to the
microscope main body.
Lamp is not installed.
(for E200 MV series only)
Lamp is burnt out.
(for E200 MV series only)
Incorrect lamp is used.
(for E200 MV series only)
Causes
Lamp is about to burn out.
(for E200 MV series only)
Power cord is not correctly connected.
Lamp is not correctly inserted into
socket. (for E200 MV series only)
Causes
Incorrect lamp is used.
(for E200 MV series only)
Chapter 8 Troubleshooting
3 Electrical
Lamp does not light when switched on.
Flickering or unstable lamp brightness.
Sudden lamp failure.
43
Corrective Measures
Insert the power cord into an electrical
outlet. (P.29)
Insert the power cord into the AC inlet.
(P.29)
Install correctly. (P.32)
Replace lamp. (P.32)
Use the specified lamp. (P.32)
Corrective Measures
Replace lamp. (P.32)
Connect correctly.
Insert correctly. (P.32)
Corrective Measures
Use the specified lamp. (P.32)
8