Registering Information On The Objective; Procedure For Turning On The Power Switch - Nikon ECLIPSE L200ND / ECLIPSE L200N Instructions Manual

4.15.3 Registering information on the objective

You can register the information to be checked on a PC or the DS-L2 with the supplied
"L200N Setup Tool" software.
For details on how to install the "L200N Setup Tool," refer to the "L200N Setup Tool
Software Manual."

4.15.4 Procedure for turning on the power switch

Follow the procedure below to turn on the system when L200ND/L200N microscope and an
external control device are connected.
<For using the fiber illuminator (for L200ND only)>
1.
Set the power switch on the fiber illuminator to the "|" side and wait until it starts up.
2.
Set the power switch on the L200ND main body to the "|" side to turn it on.
* Before using the fiber illuminator, read the instructions and the safety precautions in the
instruction manual supplied with the product.
<For using the DS-L2/DS-U2>
1.
Set the power switch on the L200ND/L200N main body to the "|" side to turn it on.
2.
Push in the power switch on the DS-L2 or DS-U2 to turn it on.
4 Assembly
47
IC Inspection Microscope ECLIPSE L200ND / L200N Instructions