Table of Contents
Advertisement
1 Disconnect this product from the power supply before assembling this product, attaching or
removing the cord, replacing the lamp, or performing maintenance.
To prevent electric shocks and failures, when you assemble this product, attach or remove the
cord, replace the lamp, or clean the main body or objectives, you must turn off this product
and other related equipment (flip the power switches to the " " side) and unplug the power
cords from the wall outlet.
2 Check the light source.
Use only the specified lamp and the lamphouse on this product. The use of other lamps and
lamphouses may lead to malfunction. For details about the specified lamp and lamphouse,
see "7 Technical specifications."
3 Cautions on lamp replacement
•
To prevent burn injury, allow the lamp to cool for at least 30 minutes after turning off the
power switch, before replacing the lamp.
•
To prevent electrical shock and damage to the microscope, always turn off the power
switch (flip it to the " " side) and unplug the power cord from the wall outlet before
connecting or disconnecting the lamphouse.
•
Do not touch the glass surface of the lamp with bare hands. Fingerprints or grease on the
bulb surface will reduce the illumination of the lamp. Wipe clean the fingerprints or grease
with a clean piece of cloth.
•
Securely attach the lamphouse cover to the lamphouse after replacing the lamp. Never
light the lamp while the lamphouse cover is open.
•
When you dispose of the replaced lamp, do not shatter it or dispose of it casually. Dispose
of the used lamp as the special industrial waste or dispose of them according to the
regulations and rules of your local authority.
4 Do not let the microscope become wet.
Do not get this product wet. In addition, do not use this product in an environment where water
will get into this product. If the product gets wet, a short circuit may result that may cause
malfunction or abnormal heating of the product. If you accidentally spill a liquid on the
microscope, immediately turn off the power switch (flip it to the " " side) and unplug the power
cord from the wall outlet. Then use a dry cloth to wipe away the moisture. If any liquid gets
inside the microscope, do not use it; instead, notify your nearest Nikon representative.
5 Weak electromagnetic emission
This product emits weak electromagnetic waves. The accuracy of any precision electronic
equipment may be adversely affected if positioned too close. If the microscope affects TV or
radio reception, move the radio or TV further away from the microscope.
6 Installation location
This product is a precision optical instrument. Using or storing the microscope under
unsuitable conditions may damage it or may have an adverse effect on its accuracy. The
following conditions should be kept in mind when selecting the installation location.
•
Avoid a brightly lit location such as a room that receives direct sunlight, or directly under
room lights. If there is excessive ambient light, image may not clearly be visible.
•
Choose a location that is free from dust or dirt.
IC Inspection Microscope ECLIPSE L200ND / L200N Instructions
Safety Notes
CAUTION
VI
Hide quick links:
Advertisement
Table of Contents
