Removing gearbox shafts
•
Remove breather tube (3).
•
Heat bearing points in gearbox cover to
80 °C ... 100 °C (176 °F ... 212 °F).
•
Remove input shaft (4), output shaft (1) and
intermediate shaft (5) together from the cover.
•
Remove selector fork (2) from intermediate shaft.
5
4
3
Replacing grooved ball bearing on
intermediate shaft
00 7 500
e
Caution:
If the grooved ball bearings are replaced, the fully-
compressed length must be re-adjusted.
•
Pull off the grooved ball bearings with a universal
puller, BMW No. 00 7 500.
•
Press the output-side grooved ball bearing on to
the intermediate shaft.
•
Check/adjust fully assembled length (
•
Place spacing washer of calculated thickness in
position and press on the input-side grooved ball
bearing.
1
2
80...100
h
S230050
KR230070
23.17).
a
23.11