00 7 500
•
Using puller, BMW No. 00 7 500, pull taper roller
bearing off crown wheel.
00 8 560
•
Pull out the outer race using internal puller,
BMW No. 00 8 560.
Assembling/installing crown wheel
00 5 500
23 4 670
KR330190
•
Heat the housing to 80 °C (176 °F).
•
Insert the outer race in the bearing seat with drift,
BMW No. 23 4 670, and handle,
BMW No. 00 5 500.
•
Check that outer race is correctly seated by tap-
ping gently.
L
Note:
If new parts are installed (e.g. taper roller bearing),
check tooth backlash and adjust if necessary.
h
KR330200
80
80
h
•
Place the original spacer ring (1) on the crown
wheel.
•
Heat taper roller bearing (2) to 80 °C (176 °F) and
push it on.
•
Install crown wheel (3).
•
Heat grooved ball bearing (4) to 80 °C (176 °F)
and place it in position.
h
80
S330090
4
3
1
2
S330100
33.11