•
Disengage reaction link from rear wheel drive.
•
Remove fixed and floating bearing stud bolts and
remove rear wheel drive.
•
Remove screw at bottom of suspension strut.
•
Loosen floating bearing left, swinging arm to
main frame.
00 8 582
•
Loosen fixing bearing right, swinging arm to main
frame, if necessary using puller,
BMW No. 26 1 660, or puller with impact weight,
BMW No. 00 8 580.
•
Remove screw at bottom of suspension strut.
•
Remove swinging arm.
•
Remove suspension strut.
•
Use a screwdriver to press out the universal
shaft.
•
[ABS] Disconnect plug from ABS unit.
•
[ABS] Disconnect brake lines from ABS unit.
•
[ABS] Remove cover of ABS unit and disconnect
lines.
46.14
00 8 581
e
Always follow the instructions in the Repair Manual.
a Group 34/Removing ABS unit
S330160
•
[ABS] Remove the ABS unit.
•
Remove the rear side panel on the right.
•
Disconnect plug for rear wiring harness.
•
[ABS] Disconnect sensor plug.
•
Disconnect plug for brake-light switch.
•
Disconnect plug for inductive sensor,
speedometer.
•
[ABS] Remove rear brake lines.
•
Disconnect gearshift linkage from ball head.
•
Remove footrest assembly.
•
Remove rear frame.
•
Disconnect main frame and lift main frame.
•
Installation is the reverse of the removal proce-
dure, note the correct tightening sequence for
installing the main frame:
•
Install all screws and bolts except screw (4) se-
curing the frame to the gearbox.
•
Tighten screw (1) to initial torque.
•
Tighten screw (2).
•
Measure clearance between transmission hous-
ing and frame lug on left in forward direction of
travel and compensate if necessary by installing
washer (3) of correct thickness on left.
•
Tighten fastener securing frame to gearbox (4),
S330170
using new washers (5) and a new compression
nut.
•
Tighten screws (1) and (6).
•
Tighten nuts (7).
•
Tighten screws (8).
•
Fill and bleed the brake system.
•
Switch on the ignition.
•
Without starting the engine, fully open the throttle
once or twice so that the Motronic control unit
can register the throttle-valve positions.
L
Disconnecting the battery deletes all entries (e.g.
faults, settings) stored in the Motronic control unit's
memory.
Loss of settings can temporarily impair the operat-
ing characteristics when the engine is restarted.
Clearance between transmission housing and
frame lug
...................................... less than 0.5 mm (0.02 in)
Caution:
Note:
S340071