Installing The Abs Unit - BMW R 1100 S Repair Manual

Installing the ABS unit

•
Install the ABS unit.
•
Connect the central plug (5).
e
Caution:
Make sure the cable is not at an angle, or its insula-
tion may be damaged.
•
Reconnect the 2-pin plug in the correct position,
pushing the two halves fully together, and press
the two wires into the center (smaller) cable en-
tries.
•
Push the two plugs for the connecting cable/wir-
ing harness onto the threaded pins with the
crimp at the front.
•
Press the two cables into the remaining free ca-
ble entries.
•
Tighten the nuts.
e
Caution:
Always use new self-locking nuts.
X
Tightening torque:
Battery —/M5 ............................................... 3.5 Nm
Battery +/M4 .................................................. 3 Nm
•
Install a new cover.
e
Caution:
When sliding the cover on, make sure that all cables
are correctly located in their cable entries. Scrap
the old cover.
•
Screw ABS brake lines (1) to ABS unit.
•
Fill and bleed the brake system.
•
Install the fuel tank.
X
Tightening torque:
ABS unit to holder
M6 screw ...................................................... 9 Nm
Brake line to ABS unit .................................. 18 Nm
Bleed screw on ABS unit................................ 9 Nm
•
Switch on the ignition.
•
Without starting the engine, fully open the throttle
once or twice so that the Motronic control unit
can register the throttle-valve positions.
L
Note:
Disconnecting the battery deletes all entries (e.g.
faults, settings) stored in the Motronic control unit's
memory.
Loss of settings can temporarily impair the operat-
ing characteristics when the engine is restarted.
34.18