h
120
•
Bolt the rear wheel drive to the retaining fixture,
BMW No. 33 1 510/511.
•
Bolt the locking arm (1) to the retaining fixture.
•
Screw threaded bushings (2) down on to the rear
wheel drive and secure them with the wheel
studs.
•
Heat hex nut (3) at the input bevel pinion to
100 °C (212 °F) and unscrew with w/f 36 socket
wrench insert and reduction adapter,
BMW No. 33 1 720.
L
Note:
If necessary, use cross-handle with two tubular ex-
tensions.
•
Pull off thrust ring (4).
•
Heat the housing to max. 120 °C (248 °F) and un-
screw threaded ring (5) with pin wrench,
BMW No. 33 1 700.
•
To remove the input bevel pinion (6), remove the
crown wheel.
............................See "Removing crown wheel"
a
•
Heat the bearing seat to max. 120 °C (248 °F).
•
Using an aluminium drift, carefully force the input
bevel pinion outwards and remove it.
33.6
2
1
120
h
33 1 510
33 1 720
5
100
h
4
3
33 1 700
6
S330030