•
Use a screwdriver to press out the universal
shaft.
•
Disconnect plug for air-temperature sensor from
air filter box.
•
Release hose clips at the air intake necks.
•
Push the air intake necks into the air filter box.
•
Use pliers, BMW No. 17 5 500, to release hose
clip securing breather hose to air filter box.
•
Remove air filter box.
•
Remove starter-motor cover.
•
Remove the starter motor.
•
Disconnect plug for gearshift switch.
•
Release the clutch slave cylinder and pull it out
of the housing.
•
Release the battery carrier and pull it up and out
of the rubber mount.
•
Remove the fuel distributor with injectors.
•
Remove the gearbox.
23 1 820
23 1 820
•
Always use guide pins, BMW No. 23 1 820, when
removing or installing the gearbox.
•
Installation is the reverse of the removal proce-
dure.
•
Switch on the ignition.
•
Without starting the engine, fully open the throttle
once or twice so that the Motronic control unit
can register the throttle-valve positions.
23.6
L
Note:
Disconnecting the battery deletes all entries (e.g.
faults, settings) stored in the Motronic control unit's
memory.
Loss of settings can temporarily impair the operat-
ing characteristics when the engine is restarted.
S330170
RS230010