Frequency Offset; Tuning Step - Icom ic-U80 Instruction Manual

D Frequency offset
Sets the frequency offset to between 0 and 20 MHz, for re-
peater operation.
The frequency offset means the difference between the
transmit and receive frequencies.
(default: differs depending on the version)
D Reverse duplex function
Turns the Reverse Duplex function ON or OFF.
D Tuning step
Selects the tuning step from 5, 10, 12.5, 15, 20, 25, 30 and
50 kHz.
(default: differs, depending on the version)
D Scan resume setting
Sets the scan resume setting to SCt. 5, SCt. 10, SCt. 15, or
SCP. 2.
When a signal is received during a scan, the scan pauses
and then resumes according to the scan resume setting.
• SCt. 5/10/15 : The scan pauses for 5, 10 or 15 seconds, and then
• SCP.2
(default: OFF)
D Function key timer
Push [FUNC](M) to enter the Function mode, and then push
a keypad key to activate its second function.
• During the Function mode, "
Set the time between when Function mode is entered, and
how long it remains activated after you push the keypad key
to activate its second function.
• F0.At
• F1/2/3.At : The Function mode remains activated for the selected pe-
• F .m
SET MODES
resumes. (default: SCt. 15)
: The scan pauses until the received signal disap-
pears, and then resumes after 2 seconds.
" is displayed on the LCD.
: Exits the Function mode immediately after a key is
pushed to activate its second function. (default)
riod after a key is pushed to activate its second function.
: The Function mode remains activated until [FUNC](M)
is pushed again, even after a key is pushed to activate
its second function.
10
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
41