Installing The Remote Control Devices - TOHATSU 40B2 Owner's Manual

3. Installing the remote control devices

WARNING
!
When using other than Tohatsu's genuine
remote control box, DO NOT select the
one without neutral safety switch that
prevents in-gear start.
Use of remote control box without neutral
safety switch can allow start of engine with
gear at other than neutral shift, potentially
leading pasengers to falling or causing
passenger to be thrown overboard.
30, 40, 50
It is recommended that you consult with
your authorized dealer for installation
adjustment of the remote control device.
■ Installation of the Remote Control
Cables (Box side) :
F o l l o w t h e i n s t r u c t i o n m a n u a l
provided with the remote control box.
■ Installation of the Remote Control
Box on your boat :
F o l l o w t h e i n s t r u c t i o n m a n u a l
provided with the remote control box.
■ Connecting the Remote Control
Cable to the engine [40, 50] :
① Detach the top cowl by turning the
lever.
② Detach the bracket and Grommet.
Put Remote Control Cabies through
the hole of upper grommet.
And then set Cord Ass'y B and
Meter lead wire (in case of use
meter) on hollow of the lower
grommet.
Having fixed the Remote Control
Cables to the bracket, tie them to
the bottom cowl.
Bracket
Shift Cable
Throttle
Clutch
Cable Cable
Cord
Meter
Ass' y B
lead wire
Battery Cord
CAUTION
!
Be careful not to loop the remote
control cables to a diameter of 406 mm
(16 inches) or less.
③ Detach the throttle and shift cable
joints by removing the R-shaped
pins.
Throttle
Cable
Joint
R shaped
pin
Washer
25
INSTALLATION
Screw
Throttle Cable
Grommet
Washer
R shaped
pin
Shift Cable Joint
4