Propeller Selection; Installing The Remote Control Devices - TOHATSU MD 30B2 Owner's Manual

ENOM00631-0
Power trim and Tilt type
EPTO 75, 90, 115
1
4
1. Bolt (12 mm × length 105 mm)
2. Washer (large diameter)
3. Nut
4. Washer (small diameter)
327
(12.9")
17.5 (0.7")
17.5 (0.7")
ø13
17.5 (0.7")
(0.5")
251
(9.9")
1. Top of transom
ENON00603-0
Notes
1. Apply sealing agent such as silicon
sealer between bolts and transom
board holes before tightening bolts.
2. Be sure to tighten mounting bolt nuts to
specified torque.
2
3
ENOF00614-0
1
51 (2")
ENOF00615-0
ENOM00632-0

2. Propeller selection

A propeller must be selected so that the
engine rpm measured at wide open throt-
tle while cruising is within the max. operat-
ing range;
5150–5850 rpm
For genuine propellers, refer to Propeller
Table of this manual.
ENON00604-0
Note
The 75, 90, 115 model is supplied with no
standard propeller. In other words, it is
shipped from the factory without a propeller.
ENOM00633-0
3. Installing the remote control
devices
ENOW00010-0
WARNING
When using other than Tohatsu's genuine
remote control box, DO NOT select the one
without neutral safety switch that prevents
in-gear start.
Use of remote control box without neutral
safety switch can allow start of engine with
gear at other than neutral shift, potentially
leading passengers to falling or causing
passenger to be thrown overboard.
ENOM00634-0
30, 40, 50
It is recommended that you consult with
your authorized dealer for installation
adjustment of the remote control device.
27
INSTALLATION