TOHATSU 40B2 Owner's Manual page 71

■ Washing (continued)
(for 75・90 and 115 model)
◎ Stand the engine upright. (Don't
p u t t h e e n g i n e i n t h e t i l t - u p
condition.)
◎ Remove the flushing connector
cap located in the left side of the
bottom cowl.
◎ Install the flushing attachment
( h o s e j o i n t ) s u p p l i e d a s a n
a c c e s s o r y t o t h e f l u s h i n g
c o n n e c t o r a n d t h e n c o n n e c t
a rubber hose to the flushing
attachment. Connect the other
end of the rubber hose to a faucet
(water tap) and turn on the faucet
to wash the engine.
＊ It is not required to run the engine
during this washing.
Flushing connector cap
WARNING
!
Do not start engine without removing
propeller, or accidentally turning
propeller could cause personal injury.
CAUTION
!
Keep engine at idle speed during flushing.
Flushing
attachment
(Hose joint)
Hose
INSPECTION AND MAINTENANCE
Replacing the propeller
A worn-out or bent propeller will lower
the motor's performance, and cause
engine trouble.
Before removing the propeller, remove
the spark plug caps from the spark
plugs to protect against personal
injury.
WARNING
!
Do not begin propeller removal and
installation procedure with spark
plug caps attached, shift in forward
or reverse, main switch at other than
"OFF", engine stop cord attached to
the switch, and starter key attached, or
engine could accidentally start leading
to serious personal injury. Disconnect
battery cable if possible.
① Pull out the split pin and remove
the propeller nut and washer.
② Remove the propeller by pulling
toward you.
③ Apply genuine grease to the
propeller shaft before mounting
the new propeller.
④ Fit the washer, securely tighten the
nut and insert the split pin.
Propeller
Propeller
thrust
holder
Propeller shaft
Drive sleeve
Thrust washer
71
Split
pin
Nut
Stopper
Washer
Drive
sleeve
adapter
Drive sleeve type
10