CAUTION
!
You may be injured due to high engine
temperatures if you fill engine oil just
after stopping. Changing engine oil
should be done after the engine has
been cooled.
CAUTION
!
● Do not overfill engine oil, or engine
oil could leak and/or engine could be
damaged. If engine oil level is over
upper limit marks of oil gauge, drain
oil to level lower than upper limit.
● Be sure that outboard motor is in
upright and level position when
checking or changing oil.
● Stop engine immediately if low oil
pressure warning lamp is lit or oil
leak is found, or engine could be
severely damaged. Consult dealer.
Notes
● If any amount of water is found in
engine oil, making it milky white,
consult dealer.
● If engine oil is contaminated with
fuel, emitting strong fuel smell,
consult dealer.
INSPECTION AND MAINTENANCE
Checking and Refilling Oil in the
Power Trim & Tilt.
① Check the oil level of the reservoir
tank as shown on the right while
the tank is kept in a ver tical
position. Tilt the engine up to
check the oil level in the tank.
Remove the oil cap by turning
counter-clockwise, then check if
the oil level reaches the bottom
line of the plug hole.
Oil cap
Oil cap
Oil level
75 90 115
30 40 50
WARNING
!
● Be sure that outboard motor is
secured to transom or service
stand, or accidental drop or fall of
outboard motor could lead to severe
personal injury.
● Be sure to lock outboard motor if
it is tilted up, or accidental fall of
outboard motor could lead to severe
personal injury.
● Do not go under outboard motor
tilted up and locked, or accidental
fall of outboard motor could lead to
severe personal injury.
77
Oil
level
10