TOHATSU 40B2 Owner's Manual page 27

⑥ Adjust the cable joint (shift side) so
that the hole meets with the shift
arm pin, and lock the cable joint
with the nut, and insert the shift
arm pin and then secure with a
washer and R-shaped pin. Also,
adjust the cable joint (throttle
side) so that the hole meets with
the advancer arm pin, and lock
the cable joint with the nut, and
insert the advancer arm pin and
then secure with a washer and
R-shaped pin.
Rod snap
Link rod
R shaped pin Nut
⑦ Place and fix Cable harness B to
P.T. switch bracket as shown.
P.T. Switch Bracket
Band
Connecting the Remote Control Cable
to the engine [75, 90, 115]
① Turn the three hook levers fastening
② Remove the hose clamp fastening
Hole for
Cable Joint
cord ass' y B
Throttle
Cable
Hole for meter
cord ass' y
Bolt
Screw
Bracket
③ Detach the throttle and shift cable
the bottom cowl and then remove
the top cowl.
the cord grommet.
Remove the bolts fastening the
cord clamp and then remove the
cord clamp and the cord grommet.
Hose clamp
Hole for remote
control cable of
Shift side
Bolt
Cord clamp
Cord grommet
Joints by removing the R-shaped
pins.
27
INSTALLATION
Hook lever
Hole for
trim sender
extension cord
Hole for remote
control cable of
throttle side
Hole for fuel hose
Hose clamp
4