TOHATSU 40B2 Owner's Manual page 26

26 INSTALLATION
◎ Screw the tip of the remote control
cable into the cable joint up to
approx. 10mm (0.39inch), then
lock them with a lock nut. Apply
grease to the hole of the cable
joint.
Remote control cable
4
④ Move the Remote Control lever
Forward, to Neutral and to Reverse
to confirm the shift is working, and
then set the lever to Neutral.
◎ Double-check that the Remote
Control Cables, the throttle cable
and shift cable have been connected
correctly. Move the Remote Control
Lever Forward until the first engaging
point (approx 32˚). The cable which
is moved first when the lever is
turned is a shift cable. Check that
Lock nut
Cable joint
Approx. 10 mm (0.39 inch)
Fully opened
Free Accel
lever
Fully
closed
the shift lever is in Neutral and the
Free Accel lever is fully closed
when the remote control cables
have been connected.
⑤ Set the shift arm to the Neutral(N)
position and close the advancer arm
completely.
If the advancer ar m does not
contact with the stopper, the
throttle position sensor will be
active improperly.
◎ The advancer arm should have
contact with the stopper at neutral
position of the remote control lever.
Shift arm
R
Advancer arm
N
F
Fully closed
Stopper
(Throttle fully
closed side)