TOHATSU 40B2 Owner's Manual page 43

Hide thumbs Also See for 40B2:
Table of Contents

Advertisement

■ Battery voltage too low
If the battery voltage drops to 10 V or
lower, the warning lamp flashes.
And also if the voltage is too high, all
of the three warning lamps flash.
If the battery is defective or the
battery cable is poorly connected, the
warning lamp flashes and the engine
speed is automatically slowed down
to 2,800 to 3,200 rpm. If the defect is
serious, the engine will stop.
Battery warning lamp
Remedy:
◎ Check the battery cable connection.
If there is a poor connection,
reconnect it tightly.
◎ Charge the battery.
◎ Replace the battery with a new
one.
PRE-OPERATING PREPARATIONS
■ Engine trouble
In case of an engine trouble, all the
three warning lamps flashes at the
same time.
Note
This warning system has three kind
indications with cause of engine
trouble as below.
① The warning lamp flash
② The engine speed control 2,800
~3,200 rpm and the warning lamp
flash
③ The engine speed control 700~900
rpm and the warning lamp flash.
Remedy:
Consult your dealer about the trouble,
because the engine needs inspection
and repair service by an authorized
serviceman in this case.
43
5

Advertisement

Table of Contents
loading

This manual is also suitable for:

50b290c2115a275c2Md 30b2

Table of Contents