Installing The Remote Control Devices - TOHATSU M 9.9 Owner's Manual

18
INSTALLATION

2. Installing the remote control devices

It is recommended that you consult
w i t h y o u r a u t h o r i z e d d e a l e r f o r
installation adjustment of the remote
control device.
■ Installation of the Remote Control
Cables (Box side) :
3
Fo l l o w t h e i n s tr u cti on m an u al
provided with the remote control.
■ Installation of the Remote Control
on your boat :
Fo l l o w t h e i n s tr u cti on m an u al
provided with the remote control.
■ Installation of the Remote Control
Cable (engine side) and the Cord
Assembly (Wiring Harness) :
�������
!
When using other than Tohatsu's genuine
remote control box, DO NOT select the
one without neutral safety switch that
prevents in-gear start.
Use of remote control box without
neutral safety switch can allow start of
engine with gear at other than neutral
shift, potentially leading passengers to
falling or causing passenger to be thrown
overboard.
1 Fitting of holder cap and sleeve B
guide
Throttle side......Fit the holder cap
to the end of the cable and fix it
by the nut.
Holder
cap
Spring
Ball Washer
holder
Nut
Throttle cable
Shift side......Fit the sleeve B guide
to the end of the cable and fix it
by the nut.
Sleeve B guide
Lock pin
Nut
Spring
Spring pin Shift cable
�������
!
Be careful not to loop the remote
control cables to a diameter of 406
mm (16 inches) or less.
Cable outer
groove
Cable outer
groove