Periodic Inspection - TOHATSU 40B2 Owner's Manual

2. Periodic inspection

It is important to inspect and maintain your outboard motor regularly. At each
interval on the chart below, be sure to perform the indicated servicing. Maintenance
intervals should be determined according to the number of hours or number of
months, whichever comes first.
For periodic inspection and maintenance, consult your servicing dealer.
Description
Fuel filter
High pressure
fuel filter *1
Piping/Hoses *2
Fuel tank *2
Fuel tank cap *2
Fuel System/
Fuel pump *1
Compression
System
Air filter
Drive belt *1
Fuel Pressure *1
Air Pressure *1
Ignition Spark plug
Starter motor *1
Starting
System
Battery
*1 Have this handled by your dealer
*2 In USA, you have to use EPA approved part.
(See P36 - P37 ).
Inspection intervals
First 20 Every 50 Every 100 Every 200
hours or hours or hours or hours or
1 month 3 months 6 months 1 years
Replace
○ ○
Replace
Replace
○ ○ ○
○ ○ ○
○ ○ ○
○ ○ ○
○
○
○
○
○ ○
○
○ ○ ○
INSPECTION AND MAINTENANCE
Inspection
procedure
Check and clean or
○
Replace if necessary.
Replace every 200
○
hrs or 2 years
Check and clean or
○
Replace if necessary
○
Clean
Check and clean or
○
Replace if necessary.
Check and clean or
○
Replace if necessary.
Check and clean or
○
Replace if necessary.
Check and Replace if
○
necessary.
Check and replace
○
defective parts if
necessary.
Check and replace
○
defective parts if
necessary.
Remove carbon
○
deposits or Replace if
necessary.
Check for salt
deposits and the
○
battery cable
condition.
Check installation,
○
fluid quantity, gravity.
Notes
Your outboard motor should receive
careful, and complete inspection at
300 hours. This is the best time for
major maintenance procedures to be
carried out.
73
Remarks
Entire cartridge
Including filter
0.8-0.9mm
(0.031-0.035in)
10