Installing The Remote Control Devices - TOHATSU MFS 15C Owner's Manual

2. Installing the remote control devices

WARNING
!
When using other than Tohatsu's genuine
remote control box, DO NOT select the
one without neutral safety switch that
prevents in-gear start.
Use of remote control box without neutral
safety switch can allow start of engine with
gear at other than neutral shift, potentially
leading passengers to falling or causing
passenger to be thrown overboard.
It is recommended that you consult with
your authorized dealer for installation
and adjustment of the remote control
device.
■ Installation of the Remote Control
Cables (Box side) :
Follow the instruction manual
provided with the remote control.
■ Installation of the Remote Control
on your boat :
Follow the instruction manual
provided with the remote control.
■ Installation of the Remote Control
Cable (engine side) and the Cord
Assembly (Wiring Harness) :
① Fitting of connecting parts to
cables
Screw the tip of the remote control
cable into the cable joint up to
approx. 10 mm (0.39 inch), then lock
them with a lock nut. Apply grease to
the hole of the cable joint.
Lock nut
Remote control cable
② Fitting of Remote Control Cable to
Engine.
Note
Put the control lever in the Neutral
position and the Free Accel lever in
the fully closed position.
CAUTION
!
Be careful not to loop the remote control cables
to a diameter of 406 mm (16 inches) or less.
17
INSTALLATION
Cable joint
Approx. 10mm
(0.39 inch)
Cable
Harness B
Shift Cable
Throttle Cable
Drag Link
4