Installing The Remote Control Devices - TOHATSU MFS 4C Owner's Manual

16
INSTALLATION
1. Option
1
1. Clamp screw
ENON00401-0
Note
It is recommended to install upper mounting
bolts with bolt head at inside surface of tran-
som. Bolts with threaded end at inside sur-
face of transom can cause personal injury.
ENOW00009-0
WARNING
 Mounting the outboard motor without
following this manual can lead to unsafe
conditions such as poor maneuverabil-
ity, lack of control or fire.
 Loose clamp screws and/or mounting
bolts can lead to the release or displace-
ment of the outboard motor, possibly
resulting in lost of control and/or serious
personal injury. Be sure that fasteners
are tightened to the specified torque (30
Nm (3.0 kgf) 13 ft-lb). Check the fasten-
ers for tightness from time to time.
1
ENOF00411-0
ENOF00412-0
 Be sure to use outboard mounting fas-
teners included in the outboard motor
package or their equivalents in terms of
size, material, quality and strength.
Tighten fasteners to the specified torque
(30 Nm (3.0 kgf) 13 ft-lb). Test cruise to
c h e c k i f f a s t e n e r s a r e t i g h t e n e d
securely.
 Outboard motor mounting must be per-
formed by trained service person(s)
using lift or hoist with sufficient capacity.
ENOM00405-0
2. Installing the remote control
devices
It is recommended that you consult with
your authorized dealer for installation and
adjustment of the remote control device.
ENOW00010-0
WARNING
When using other than Tohatsu's genuine
remote control box, DO NOT select the one
without neutral safety switch that prevents
in-gear start.
Use of remote control box without neutral
safety switch can allow start of engine with
gear at other than neutral shift, potentially
leading passengers to falling or causing
passenger to be thrown overboard.