Table of Contents
Advertisement
1. Press [MENU], move the ShuttlePoint knob to highlight NMEA DISPLAY and press
[ENT].
2. Move the ShuttlePoint knob to highlight DATA and press [ENT].
3. The NMEA DATA page is shown.
4. Connect the Blue Wire on the GPS Chart Plotter to the junction of the Brown wire and
the VHF wire. The display should look similar to the following picture.
2.12
VIDEO INPUT
By accessing this menu it is possible to see images on the CP390i or CPF390i display from
an external video signal source, if connected to the CP390i or CPF390i.
It allows the "picture-in-picture" functionality, so a Video Input image can be shown on a
window and placed over the Chart, Navigation, Highway, Celestial and NMEA pages image
at full screen.
If the Video Input signals is not detected (E.g. the video camera is not connected to the Video Input
connector), the VIDEO INPUT menu item will be grayed out.
Video Connector
Pin
Description
1
Ground
2
+ 9 / 12 VDC
3
Video Signal +
2.12.0 Video Camera Input
The CP390i or CPF390i has one connection for video camera. Any NTSC or PAL camera
will operate correctly. To connect use the video output of the camera and connect to the
optional ACVC10 cable.
2.12.1 VCR or DVD Input
A VCR or DVD may be connected to Video port. The CP390i or CPF390i does not have
speakers so the audio from the VCR or DVD would have to be routed to a stereo system.
STANDARD HORIZON offers an optional cable called ACVC10 that allows any VCR or
DVD to simply be plugged into the CP390i or CPF390i.
Page 24
Figure 2.11 - NMEA Data page
NOTE
Connection Example
Connect to Video Signal Ground of DVD/VCR/Video Cameras
Connect to Video Cameras Power Input
Connect to Video Signal + (NTSC/PAL) of DVD/VCR/Video Cameras
CP390i and CPF390i
Advertisement
Table of Contents
