Table of Contents
Advertisement
Installing the KISS-Stor 0/5
Installing the KISS-Stor 0/5
The KISS-Stor 0/5 is delivered with installed firmware and installed RAID level
jumper corresponding the ordered RAID level configuration.
The KISS-Stor 0/5 can be installed inside a computer case. The hardware
requirements are described in the "Computer System Requirements" chapter.
KISS-Stor 0/5 Physical Installation Procedure
Please follow these steps to install the KISS-Stor 0/5 into the case of a computer
system:
1. Turn off your system and disconnect the power cord from power source.
2. Loosen and remove the cover and faceplates from the computer case
(depends on the type of computer case). Retain the screws for later use.
3. Loosen and remove the drive cage of the computer case (depends on the type
of computer case). Retain the screws for later use.
4. Remove the metal expansion slot inserts, if you intend to install the supplied
serial 3-pin cable connector (RS232) with a 9-pin D-SUB connector attached
to a slot mounting bracket for using the KSView management software.
5. Make sure that the SATA interface cable will reach the device in its intended
location.
6. Ensure that a the power cable from the power supply will reach the RAID
subsystem in its intended location.
7. Unlock and remove the drive carriers from the KISS-Stor 0/5.
28
Only trained and qualified personnel should be allowed to
install or replace this equipment.
Before attempting to install KISS-Stor 0/5, the computer must
be powered-down and the power cord has to be disconnected
from the power source.
Please observe, that only the supplied M3x5 screws may be
used for the mounting of the KISS-Stor 0/5 to the drive cage
of the computer.
KISS-Stor 0/5 – User's Manual
Advertisement
Table of Contents
