Raid Level Configuration Jumper Pins - Kontron Kiss-Stor 0/5 User Manual

RAID Level Configuration Jumper Pins

Kontron delivers the KISS-Stor 0/5 in pre-configured RAID level depending on the
ordered configuration (RAID 0 or RAID 5). The RAID level can be re-configured
manually using the RAID level configuration jumper pins located on the rear side
of the KISS-Stor 0/5.
Fig. 9: Label on the rear side of the KISS-Stor 0/5 for proper RAID 0 and RAID 5 level
KISS-Stor 0/5 – User's Manual
Please do not change the pre-installed RAID level
configuration. The setting of RAID level jumper
configuration for RAID 0 and RAID 5 are included in the
manual as control information only. The changing of the
RAID-level could result in data loss.
Kontron assumes no responsibility for damage or loss
of data by using of the KISS-Stor 0/5.
To prevent the loss of data stored on a RAID array,
Kontron recommends to create a copy of your data
either on the internal HDD if available, or on an external
removable drive (CD/DVD/HDD/HDD stick).
The system must be powered down and disconnected
from the power source before attempting to change the
RAID level of the KISS-Stor 0/5.
configuration
RAID 0: there are set the two jumper caps over the top pairs
of the ten RAID configuration jumper pins (refer to R0 of the
RAID configuration label).
RAID 5: the ten RAID configuration jumper pins are clear of
any jumper caps pins (refer to R5 of the RAID configuration
label).
Product Description
23