Scope Of Delivery; Computer System Requirements - Kontron Kiss-Stor 0/5 User Manual

Scope of Delivery

Scope of Delivery
q KISS-Stor 0/5, configured as RAID 0 or RAID 5 (corresponding to the ordered
RAID configuration)
q Disk drive mounting screws
q Two keys for drive carriers (identical)
q One serial 3-pin cable connector (RS232) with a 9-pin D-SUB connector
attached to a slot mounting bracket
q CD-ROM with KISS-Stor 0/5 User's Manual and KSView Management
Software
q
1x SATA cable (50 cm)

Computer System Requirements

In order to install the KISS-Stor 0/5 subsystem into a working system is required a
computer system with following hardware requirements:
q with free on-board (motherboard or SBC, depending on the computer
configuration) SATA port or a serial host bus adapter card
q with one free connector (4-pin) of the power supply at least
q case with two half-height 5 ¼" drive bays with frontal access
System Requirements Option for use of the KSView Management Software
The KSView Management Software is applicable for a computer system
configuration:
q with a free expansion slot to implement the RS232 serial interface (the
included bracket with 9-pin D-SUB serial connector of the serial 3-pin cable
connector) and a free external accessible serial port configured as RS232.
The KSView Management Software uses the serial port (COM) for RAID
monitoring.
or
q with on-board SATA controller (the installed motherboard or SBC should be
equipped with an Intel® ICH5, ICH6, ICH7 SouthBridge). The KSView
Management Software uses the SATA port for RAID monitoring.
Operating System Requirements
Windows 2000, Windows 2003 or Windows XP
10 KISS-Stor 0/5 – User's Manual