Sensor (Fuser Exit) Lag Jam - Lexmark X940e Service Manual

Step
12 Perform a print test.
Does the error continue?

202.00 Sensor (fuser exit) lag jam

Step
1 Check the media position.
Does the media touch the sensor (fuser exit)?
2 Check the sensor (fuser exit) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch BASE SENSOR TEST.
3. Touch Media Path.
4. Touch Fuser exit.
Caution: The area around the actuator is very hot. Allow
the fuser area to cool before proceeding.
Does the display on the operator panel, change every time
the sensing area of the above sensor is interrupted or
blocked?
3 Check the sensor (fuser exit) for proper connection.
Is the above component properly connected?
4 Check the duplex diverter gate solenoid for proper
operation.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch Printer Motor Test.
4. Touch Duplex diverter gate solenoid.
Does the above component operate properly?
5 Check the duplex diverter gate solenoid for proper
connection.
Is the above component properly connected?
Check
Check
Caution: When performing motor tests,
ensure that all cover and door interlock
switches are overridden.
Yes
Replace the lower Problem solved.
printer engine card
assembly.
Go to "Lower
printer engine
card assembly
removal" on
page 4-77.
Yes
Remove the Go to step 2.
media.
Go to step 4. Go to step 3.
Replace the Replace the
sensor (fuser exit). connection.
Go to "Sensor
(fuser exit)
removal" on
page 4-25.
Go to step 6. Go to step 5.
Replace duplex Replace the
media inverter connection.
assembly.
Go to "Duplex
media inverter
assembly
removal" on
page 4-9.
Diagnostic information
7510-XXX
No
No
2-43