Too Short Size Jam - Lexmark X940e Service Manual

Step
8 Check the sensor (ADF width APS 3) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SCANNER TESTS.
3. Touch Sensor Tests.
4. Touch ADF width APS 3.
Does the display on the operator panel, change every time
the sensing area of the above sensor is interrupted or
blocked?
9
Check the sensor (ADF width APS 3) for proper connection.
Is the above component properly connected?
10 Perform a POR.
Does the error remain when the power is turned off/on?
11 Place an undamaged document in the ADF, and perform a
ADF test.
Does the error remain?

295.03 Too short size jam

Step
1 Check the document size.
Is the correct size document being inserted into the ADF?
2 Check the sensor (sheet through) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SCANNER TESTS.
3. Touch Sensor Tests.
4. Touch Sheet through.
Does the display on the operator panel, change every time
the sensing area of the above sensor is interrupted or
blocked?
Check
Check
Yes
Go to step 10. Go to step 9.
Replace the Replace the
sensor (ADF connection.
width APS 3).
Go to "Sensor
(ADF width
APS 3)
removal" on
page 4-145.
Replace the Problem solved.
ADF controller
card assembly.
Go to "ADF
controller card
assembly
removal" on
page 4-135.
Go to step 11.
Replace the RIP Problem solved.
card assembly.
Go to "RIP card
assembly
removal" on
page 4-71.
Yes
Go to step 2. Insert the proper
size document into
the ADF.
Go to step 4. Go to step 3.
Diagnostic information
7510-XXX
No
No
2-103