Sensor (Adf Inverter) Static Jam - Lexmark X940e Service Manual

Step
2 Check the sensor (document set) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SCANNER TESTS.
3. Touch Sensor Tests.
4. Touch Document set.
Does the display on the operator panel, change every time
the sensing area of the above sensor is interrupted or
blocked?
3
Check the sensor (document set) for proper connection.
Is the above component properly connected?
4 Place an undamaged document in the ADF, and perform a
ADF test.
Does the error remain?
5
Place an undamaged document in the ADF, and perform a
ADF test.
Does the error remain?

294.00 Sensor (ADF inverter) static jam

Step
1 Check the media path.
Is the media path free of media or media fragments?
2 Check the sensor (ADF inverter) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SCANNER TESTS.
3. Touch Sensor Tests.
4. Touch ADF inverter.
Does the display on the operator panel, change every time the
sensing area of the above sensor is interrupted or blocked?
Check
Check
Yes
Go to step 4. Go to step 3.
Replace the Replace the
sensor (document connection.
set).
Go to "Sensor
(document set)
removal" on
page 4-154.
Replace the ADF Problem solved.
controller card
assembly.
Go to "ADF
controller card
assembly
removal" on
page 4-135.
Go to step 5.
Replace the RIP Problem solved.
card assembly.
Go to "RIP card
assembly
removal" on
page 4-71.
Yes
Go to step 2. Remove any
media or media
fragments.
Go to step 4. Go to step 3.
Diagnostic information
7510-XXX
No
No
2-93