Engine Adjust - Lexmark X940e Service Manual

7510-XXX

ENGINE ADJUST

To begin PH Adjust (media tray registration), the test page must be printed.
To print the test page the printer must be in standard mode.
1. Select Menus.
2. Select Reports.
3. Select Network Setup Page
The following report prints.
Using a fine incremental ruler, measure from the black line border to the edge of the media. Ideally, the borders
should be centered on the page.
To perform the ENGINE ADJUST settings:
1. Select ENGINE ADJUST from the Diagnostics Menu.
The following tests appear on the LCD:
Select the
Then select: (
following:
PH Adjust Adj Side Reg ALL (appears on LCD)
(Media tray
(Adj side reg all trays)
registration)
Adj Side Reg MSI (appears on LCD)
(Adj side reg MPF)
Adj Side Reg DUP (appears on LCD)
(Adj side reg duplex)
3-26
MFP Service Manual
Appears on the LCD:
Registration values appear on the
LCD. If required, reset the values
and Select
to submit the changes.
Registration values appear on the
LCD. If required, reset the values
and Select
to submit the changes.
Registration values appear on the
LCD. If required, reset the values
and Select
to submit the changes.