Lexmark X940e Service Manual page 370

7510-XXX
PRO-CON (ATC sensor setup and adjust)
This procedure is used to adjust the following:
Sensor (C ATC)
Sensor (M ATC)
Sensor (Y ATC)
Sensor (K ATC)
Select PRO-CON and select:
ATC Sensor Adjust values
(
ATC Sensor Adjust Cycle
RegCon (color registration)
This procedure is used to adjust the printhead color registration.
Select RegCon Adjust
and then select:
Measurement Cycle
Control Sensor Check Reg Control Sensor Testing...
Control Sensor Cycle Reg Control Sensor Correction Testing...
Belt Edge Learn
Select RegCon Adjust
and then select:
Control Setup Cycles Skew Fine Setup
3-28
MFP Service Manual
Then Select:
Sen Grad SNR-Y
Sen Grad SNR-M
Sen Grad SNR-C
Sen Grad SNR-K
SNR Output Ref TC-Y
SNR Output Ref TC-M
SNR Output Ref TC-C
SNR Output Ref TC-K
Appears on the LCD:
Reg Measuring Testing...
Belt Edge Learn Testing...
Then select:
IN/OUT Setup
Center Setup
Skew Rough Setup
Cycle Result Value Cycle Result Values appear on the LCD.
Appears on the LCD
Registration values appear on the LCD. If
required, reset the values and Select
submit the changes.
Registration values appear on the LCD. If
required, reset the values and Select
submit the changes.
Registration values appear on the LCD. If
required, reset the values and Select
submit the changes.
Registration values appear on the LCD. If
required, reset the values and Select
submit the changes.
Registration values appear on the LCD. If
required, reset the values and Select
submit the changes.
Registration values appear on the LCD. If
required, reset the values and Select
submit the changes.
Registration values appear on the LCD. If
required, reset the values and Select
submit the changes.
Registration values appear on the LCD. If
required, reset the values and Select
submit the changes.
Testing... Pass
Appears on the LCD:
Skew Fine Setup Testing...
IN/OUT Setup Testing...
Center Setup Testing...
Skew Rough Setup Testing...
to
to
to
to
to
to
to
to