Lexmark X940e Service Manual page 653

Step
7 Check the image density sensor assembly for toner
contamination.
Is the above component dirty or contaminated?
8 Re-Perform the Skew fine setup.
1. Enter the Diagnostics Menu.
2. Touch ENGINE ADJUST.
3. Touch RegCon adjust
4. Touch Control setup cycles
5. Touch Skew fine setup
Does the above test pass?
9 Re-Perform the Skew fine setup.
1. Enter the Diagnostics Menu.
2. Touch ENGINE ADJUST.
3. Touch RegCon adjust
4. Touch Control setup cycles
5. Touch Skew fine setup
Does the above test pass?
Check Yes
Remove and clean Go to step 8.
the image density
sensor assembly.
See "Image
density sensor
assembly
removal" on
page 4-45.
Perform the In/Out Replace the image
setup. density sensor
assembly.
See "In/out
setup" on See "Image
page 4-262. density sensor
assembly
removal" on
page
Perform the In/Out Contact next level
setup. of support.
See "In/out
setup" on
page 4-262.
Repair information
7510-XXX
No
4-45.
4-261