Sensor (Fuser Exit) Static Jam Service Check - Lexmark MX71x Service Manual

Error code Description
202.22 Cartridge Motor—Motor under‑speed error.
Motor made it to closed loop at a steady
state, but then detected speed was below
threshold
202.28 The sensor (fuser exit) rebounded upon being
released by the trailing edge of the media.
202.31 Media remains on the sensor (narrow media)
during the warm‑up sequence.
202.32 The media reached the sensor (fuser exit) but
did not clear it within the specified time.
202.33 Expected wide page not detected by sensor
(narrow media), possible accordion jam or
missing signal.
202.43 The media is late reaching the sensor (fuser
exit) within the specified time.
202.45 Media remains on the sensor (fuser exit)
during the warm‑up sequence.
202.49 Fuser info chip error

Sensor (fuser exit) static jam service check

Action
Step 1
Check the media size setup and tray guides for all media trays.
Does the media size, in use, match the size set for all media trays?
Step 2
Check the media condition in all media trays.
Is any of the media in any of the media trays crumpled or damaged?
Step 3
Reset the machine.
Does the error continue?
Action
Go to "Fuser drive motor control jam service check" on page
91.
Go to "Sensor (fuser exit) miscellaneous jam service check" on
page 99.
Go to "Sensor (narrow media) static jam service check" on
page 99.
Go to "Sensor (fuser exit) late-leaving jam service check" on
page 96.
Go to "Sensor (narrow media) late arriving jam service check"
on page 98.
Go to "Sensor (fuser exit) late-arriving jam service check" on
page 97.
Go to "Sensor (fuser exit) static jam service check" on page
95.
Go to "Fuser ID chip control jam service check" on page
Yes
Go to step 2.
Replace the damaged
media with new media.
Contact the next
highest level of
technical support.
Diagnostic information
95
7463
100.
No
Replace the media, or
change the media size
setup.
Go to step 3.
Problem solved.