Removing The Upper Bezel - IBM x3200 M3 7327 Service Manual

Removing the upper bezel

When you work with some devices, such as the drives in bays 1 through 3, you
must first remove the upper bezel to access the devices.
To remove the upper bezel, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If you are replacing a non-hot-swap component, turn off the server and all
3. Unlock and remove the side cover (see "Removing the side cover" on page
4. Remove the lower bezel (see "Removing the lower bezel" on page 147).
5. Carefully pull the two bezel clips on the left side of the upper bezel; then, rotate
6. If you are instructed to return the upper bezel, follow all packaging instructions,
on page 141.
attached devices; then, disconnect all power cords and external cables.
145).
the upper bezel to the right side of the server to disengage the two right-side
tabs from the chassis.
and use any packaging materials for shipping that are supplied to you.
Chapter 5. Removing and replacing server components
149