Removing A Hot-Swap Power Supply - IBM x3200 M3 7327 Service Manual

Removing a hot-swap power supply

This procedure applies only to server models that have hot-swap power supplies.
See "Removing a non-hot-swap power supply" on page 206 for information about
the removal of a non-hot-swap power supply.
When you remove or install a hot-swap power supply, observe the following
precautions.
Statement 8:
CAUTION:
Never remove the cover on a power supply or any part that has the following
label attached.
Hazardous voltage, current, and energy levels are present inside any
component that has this label attached. There are no serviceable parts inside
these components. If you suspect a problem with one of these parts, contact
a service technician.
165
Chapter 5. Removing and replacing server components