Removing A Memory Module - IBM x3200 M3 7327 Service Manual

Removing a memory module

To remove a dual inline memory module (DIMM), complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and all attached devices; then, disconnect all power cords.
3. Unlock and remove the side cover (see "Removing the side cover" on page
4. Locate the DIMM connector that contains the DIMM that is to be replaced (see
5. Carefully open the retaining clips on each end of the DIMM connector and
6. If you are instructed to return the DIMM, follow all packaging instructions, and
168
System x3200 M3 Types 7327 and 7328: Problem Determination and Service Guide
on page 141.
145).
"System-board optional-devices connectors" on page 18 for DIMM slot
locations).
Attention: To avoid breaking the DIMM retaining clips or damaging the DIMM
connectors, open and close the clips gently.
remove the DIMM.
use any packaging materials for shipping that are supplied to you.