Installing A Serveraid-Br10Il V2 Sas/Sata Controller - IBM x3200 M3 7327 Service Manual

3. Unlock and remove the side cover (see "Removing the side cover" on page
4. Open the rear adapter-retention bracket until the release lever on the right side
5. Squeeze the tabs on both sides of the connector on the signal cable and
6. Carefully disengage the tabs on each side of the SAS/SATA controller connector
7. Grasp the edges of the SAS/SATA controller and pull it out of the connector. If
8. If you are instructed to return the SAS/SATA controller, follow all packaging

Installing a ServeRAID-BR10il v2 SAS/SATA controller

To install the SAS/SATA RAID controller, complete the following steps:
1. Touch the static-protective package that contains the SAS/SATA controller to
2. Position the SAS/SATA controller over the connector and the plastic standoff;
145).
of the bracket clicks into place.
remove the cable from the SAS/SATA controller.
PCIe SAS slot
ServeRaid-BR10il
controller
and the front of the SAS/SATA controller from the plastic standoff.
the standoff comes away from the system board with the controller, gently pull it
out of the controller and push it back into the hole on the system board.
instructions, and use any packaging materials for shipping that are supplied to
you.
any unpainted surface on the outside of the server; then, remove the SAS/SATA
controller from the package.
then, press the SAS/SATA controller firmly into the connector and onto the
plastic standoff.
Chapter 5. Removing and replacing server components
205