Enabling The Intel Gigabit Ethernet Utility Program - IBM x3200 M3 7327 Service Manual

Obtaining the IP address for the IMM
To access the Web interface, you need the IP address for IMM. You can obtain the
IMM IP address through the Setup utility. The server comes with a default IP
address for the IMM of 192.168.70.125. To locate the IP address, complete the
following steps:
1. Turn on the server.
2. When the prompt <F1> Setup is displayed, press F1. (This prompt is displayed
3. From the Setup utility main menu, select System Settings.
4. On the next screen, select Integrated Management Module.
5. On the next screen, select Network Configuration.
6. Find the IP address and write it down.
7. Exit from the Setup utility.
Logging on to the Web interface
To log onto the Web interface to use the remote presence functions, complete the
following steps:
1. Open a Web browser on a computer that connects to the server and in the
2. On the Login page, type the user name and password. If you are using the IMM
3. On the Welcome page, type a timeout value (in minutes) in the field that is
4. Click Continue to start the session. The System Health page provides a quick

Enabling the Intel Gigabit Ethernet Utility program

The Intel Gigabit Ethernet Utility program is part of the server firmware. You can
use it to configure the network as a startable device, and you can customize where
the network startup option appears in the startup sequence.
To enable the Intel Gigabit Ethernet Utility program, complete the following steps:
1. From the Setup utility main menu, select Devices and I/O Ports and press
232
System x3200 M3 Types 7327 and 7328: Problem Determination and Service Guide
Note: Approximately 1 to 3 minutes after the server is connected to ac power,
the power-control button becomes active.
Note: Approximately 1 to 3 minutes after the server is connected to ac power,
the power-control button becomes active.
on the screen for only a few seconds. You must press F1 quickly.) If you have
set both a power-on password and an administrator password, you must type
the administrator password to access the full Setup utility menu.
address or URL field, type the IP address or host name of the IMM to which
you want to connect.
Note: The IMM defaults to DHCP. If a DHCP host is not available, the IMM
assigns a static IP address of 192.168.70.125.
for the first time, you can obtain the user name and password from your system
administrator. All login attempts are documented in the event log.
Note: The IMM is set initially with a user name of USERID and password of
PASSW0RD (passw0rd with a zero, not a the letter O). You have read/write
access. You must change the default password the first time you log on.
provided. The IMM will log you off of the Web interface if your browser is
inactive for the number of minutes that you entered for the timeout value.
view of the system status.
Enter.