10. Turn on the peripheral devices and the server.
Removing the virtual media key
To remove the virtual media key, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect all power cords; then,
3. Grasp the virtual media key and gently slide it up and off of the mounting tab.
7. Reconnect the power cord and any cables that you removed.
8. Install and lock the side cover (see "Installing the side cover" on page 146).
9. Reconnect the power cord and any cables that you removed.
on page 141.
remove the side cover (see "Removing the side cover" on page 145).
Chapter 5. Removing and replacing server components
181